crane

...now browsing by tag

 
 

The Crane Project Page

Thursday, March 18th, 2010

I’ve blogged about this project already, and I’ve finally gotten around to making a proper webpage for it on my site. Although at this point, the webpage isn’t finished yet :-)

At any rate, I just wanted to announce it and get it out there:
http://www.texbrick.com/model_craneproj



click to view page

Crane Boom – Triangular Cross Section

Thursday, June 11th, 2009

One of my next projects is to build a simple tower crane. I’ve developed a new turntable (more on that later :-) ), and I’m working on a boom with a triangular cross section.

It’s not too hard to make a triangular cross section, but it’s an added challenge to create a design that will transition between sections of different heights.

This design (below) makes use of a truss chord on the top that is oriented normally. This allows the height of the truss section to change along its length fairly easily (it’s the link between sections that becomes very difficult unless the top chord is oriented normally).



click for larger


click for larger

My goal is to build the boom of the tower crane as a cantilever type and not use guy wires as typically seen on many tower cranes. The tower base of the crane will make use of the boom sections I built for the crane project.